光学共振增强的表面铯激活银纳米结构光阴极

金属光阴极因其超短脉冲发射和运行寿命长的特性从而具有重要应用价值,但是较高的功函数和较强的电子散射使其需要采用高能量紫外光子激发且光电发射量子效率极低.本文利用Mie散射共振效应增强银纳米颗粒中的局域光学态密度,提升光吸收率和电子的输运效率,并利用激活层降低银的功函数,从而增强光阴极在可见光区的量子效率.采用时域有限差分方法分析银纳米球阵列的光学共振特性,采用磁控溅射和退火工艺在银/氧化锡铟复合衬底上制备银纳米球,紧接着在其表面沉积制备铯激活层,最后在高真空腔体中测试光电发射量子效率.实验结果表明平均粒径150 nm的银纳米球光阴极在425 nm波长的量子效率超过0.35%,为相同激活条件下银薄膜光阴极的12倍,峰值波长与理论计算的Mie共振波长相符合.     

On-chip multiphoton Greenberger–Horne–Zeilinger state based on integrated frequency combs

One of the most important multipartite entangled states, Greenberger–Horne–Zeilinger state (GHZ), serves as a fundamental resource for quantum foundation test, quantum communication and quantum computation. To increase the number of entangled particles, significant experimental efforts should been invested due to the complexity of optical setup and the difficulty in maintaining the coherence condition for high-fidelity GHZ state. Here, we propose an ultra-integrated scalable on-chip GHZ state generation scheme based on frequency combs. By designing several microrings pumped by different lasers, multiple partially overlapped quantum frequency combs are generated to supply as the basis for on-chip polarization-encoded GHZ state with each qubit occupying a certain spectral mode. Both even and odd numbers of GHZ states can be engineered with constant small number of integrated components and easily scaled up on the same chip by only adjusting one of the pump wavelengths. In addition, we give the on-chip design of projection measurement for characterizing GHZ states and show the reconfigurability of the state. Our proposal is rather simple and feasible within the existing fabrication technologies and we believe it will boost the development of multiphoton technologies.     

TADF激基复合物主体材料提升溶液法制备蓝色荧光有机发光二极管的效率

为了提升溶液法制备的蓝色荧光有机发光二极管(OLEDs)的效率,采用了基于热激活延迟发光(TADF)的激基复合物作为主体材料。TADF激基复合物主体可以利用反向系间窜跃上转换形成单线态激子并将能量传递到客体,从而可以同时利用发光层中的三线态激子和单线态激子,以提升蓝色荧光器件的效率。选择蓝色荧光材料1-4-Di-[4-(N,N-diphenyl)amino]styryl-benzene(DSA-ph)作为客体发光材料,4,4′,4″-T-ris(carbazol-9-yl)triphenylamine(TCTA)掺杂1,3,5-Tri(1-phenyl-1H-benzo[d]imidazol-2-yl)phenyl)(TPBi)作为热激活延迟荧光激基复合物主体,通过溶液法制备了蓝色荧光OLEDs。通过测试TCTA,TPBi以及TCTA掺杂TPBi的光致发光光谱发现,与TCTA和TPBi相比,TCTA掺杂TPBi的光致发光谱(PL)发生了明显的红移(峰值波长变为437 nm),而且光谱变宽,证明了TCTA∶TPBi激基复合物的形成。通过对于DSA-ph掺杂激基复合物主体的薄膜与DSA-ph掺杂poly(methyl methacrylate)(PMMA)的薄膜进行PL测试发现,两者发光峰相同,都是来自DSA-ph的发光,说明激基复合物主体将能量传递到了DSA-ph;DSA-ph的吸收光谱与激基复合物主体的PL光谱存在很大重叠,说明激基复合物主体与DSA-ph的能量传递非常有效;通过对激基复合物主体掺杂不同浓度客体的薄膜进行瞬态PL衰减测试发现,与纯DSA-ph的寿命相比,DSA-ph掺杂激基复合物主体之后其寿命会延长,纯DSA-ph的寿命只有1.19 ns,DSA-ph掺杂激基复合物主体的荧光衰减曲线与激基复合物主体的荧光衰减曲线相似,这进一步证明了激基复合物主体将能量传递到了DSA-ph。研究了主体引入以及DSA-ph掺杂浓度对器件性能的影响。对于器件的亮度、电流密度、电压、电流效率、电致发光光谱等参数进行了测试,与不采用激基复合物主体的器件相比,采用激基复合物主体的器件性能明显改善,在DSA-ph掺杂浓度为10%时,器件亮度从2133.6 cd·m^-2提升到了3597.6 cd·m^-2,器件效率从1.44 cd·A-1提升到了3.15 cd·A-1,发光峰只有来自DSA-ph的发光。采用TADF激基复合物主体的方法有潜力实现溶液法制备的高效蓝色荧光OLEDs。     

Enantioselective Copper‐Catalyzed Azide–Alkyne Click Cycloaddition to Desymmetrization of Maleimide‐Based Bis(alkynes)

A copper catalyst system derived from TaoPhos and CuF₂ was used successfully for catalytic asymmetric Huisgen [3+2] cycloaddition of azides and alkynes to give optically pure products containing succinimide‐ and triazole‐substituted quaternary carbon stereogenic centers. The desired products were obtained in good yields (60–80 %) and 85:15 to >99:1 enantiomeric ratio (e.r.) in this click cycloaddition reaction.     

Selective extraction of catecholamines by packed fiber solid‐phase using composite nanofibers composing of polymeric crown ether with polystyrene

For the first time, electrospun composite nanofibers comprising polymeric crown ether with polystyrene (PCE‐PS) have been used for the selective extraction of catecholamines – dopamine (DA), norepinephrine (NE) and epinephrine (E) – prior to their analysis by high‐performance liquid chromatography–electrochemical detection. Using a minicartridge packed with PCE‐PS composite nanofibers, the target compounds were extracted effectively from urine samples to which diphenylborinic acid 2‐aminoethyl ester was added as a complexing reagent. The extracted catecholamines could be liberated from the fiber by the addition of acetic acid. A good linearity was observed for catecholamines in the range of 2.0–200 ng mL^?1 (NE, E and DA). The detection limits of catecholamines (signal‐to‐noise ratio = 3) were 0.5 ng mL^?1 (NE), 0.2 ng mL^?1 (E) and 0.2 ng mL^?1 (DA), respectively. Under the optimized conditions, the absolute recoveries of the above three catecholamines were 90.6% (NE), 88.5% (E) and 94.5% (DA). The repeatability of extraction performance was from 5.4 to 9.2% (expressed as relative standard deviation). Our results indicate that the proposed method could be used for the determination of NE, E and DA in urine. Copyright © 2014 John Wiley & Sons, Ltd.     

Investigation of Suzuki–Miyaura catalyst‐transfer polycondensation of AB‐type fluorene monomer using coordination‐saturated aryl Pd(II) halide complexes as initiators

Novel triarylamine‐based coordination‐saturated aryl Pd(II) halide complexes ligated by PEt₃, PCy₃, and P(o‐tol)₃ were successfully synthesized by direct oxidative addition of aryl halide to the corresponding Pd(0) precursors. Suzuki–Miyaura coupling polymerization of 2‐(7‐halide‐9,9‐dioctylfluoren‐2‐yl)?1,3,2‐dioxaborinane with these Pd(II) complexes as initiators was investigated for the synthesis of poly(fluorene)s with triarylamine end group. Pd(II) complexes with PCy₃ or P(o‐tol)₃ exhibited catalytic activity and realized the catalyst‐transfer polycondensation at 75 °C and room temperature, respectively, while the polymerization using Pd(II) catalyst ligated by PEt₃ did not proceed, which indicated that the bulky phosphine ligands could facilitate the reductive elimination and further promote the polymerization. In addition, the dimeric Pd(II) complex with P(o‐tol)₃ can convert into monomeric Pd(II) intermediate with an open coordination site, which had a higher activity. The end groups of the afforded polyfluorene were analyzed by matrix‐assisted laser desorption ionization time‐of‐flight (MALDI‐TOF) mass spectrometry, in which the Ar/H end groups are indicative of the catalyst‐transfer polymerization. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1457–1463     

Surface of room temperature ionic liquid [bmim][PF6] studied by polarization- and experimental configuration-dependent sum frequency generation vibrational spectroscopy

Understanding and control of the surface properties such as molecular orientations are of great importance in numerous applications of ionic liquids. However, there remain discrepancies among the previous experimental and theoretical studies on the surface orientation and structures of room temperature ionic liquids(RTIL) systems. In this article, the orientation of 1-butyl-3-methylimidazolium([bmin]) cation at the air/liquid interface of a characteristic RTIL, 1-butyl-3-methylimidazolium hexafluorophosphate([bmim][PF6]), was investigated by the sum frequency generation vibrational spectroscopy(SFG-VS). Detailed polarization and experimental configuration analyses of the SFG-VS spectra showed the possibility of a small spectral splitting in the CH3 symmetric stretching region, which can be further attributed to the probable existence of multiple orientations for the interfacial [bmim] cations. In addition, the(N)–CH3 vibrations were absent, ruling out the prediction by several recent molecular dynamics simulations which state that portions of the [bmim] cations orient with a standing-up(N)–CH3 group at the ionic liquid surface. Hence, new realistic theoretical models have to be developed to reflect the complex nature of the ionic liquid surface.